The current chassis settings cannot be deployed to this controller.

Hello,

I have two identical cRIO-9022 with cRIO-9114 which should work with the scan engine because I don't have the FPGA licence.  I have upgraded to LabVIEW 2012 on both.  One is working fine but the other is giving me the following error:

"The current chassis settings cannot be deployed to this controller. This controller does not support the NI Scan Engine and can be used only in LabVIEW FPGA Interface mode. Use the CompactRIO Chassis Properties page to change the programming mode of the chassis to LabVIEW FPGA Interface."

On the property page it is set to "Scan Engine"....

Anyone has a clue?

Thanks,

Michel