Hey all,
I'm running a Yokogawa DL6104 oscilloscope through LabVIEW with a Yokogawa DL9000 driver (which supports model DL6104). I'm trying to acquire several waveforms using the N-single acquisition mode through a revised Edge Triggered Acquisition.vi example, wherein I created controls for the trigger's -mode and -counts on the YKDL9000 Config Edge Trigger sub VI.
Still, I'm getting no luck. I receive this error:
YKDL9000 Error Query;
instrument reports:
662,"Acquisition in process in N Single trigger mode. Press Run/Stop key or wait until the process is completed."
0,"No error"
Can anyone help guide me to what my mistake is, and perhaps direct me to resolving the problem?
Big Thanks!
- Ryan