My application consists of a Labview User Interface that calls a Teststand sequence.
The UI is very similar to what gets installed by default with TestStand.
In the TS sequence there are calls to VIs. Some of them are to the Virtual Bench 8012 driver.
It works well.
But when I exit the Operator Interface Labview crashes. I did debug a little bit and the crash
occurs when trying to close the Teststand Engine.
If in the Teststand sequence I skip the calls to the VB8012 driver then the Labview crash does not happen.
I am using LV2013 but TestStand2010.
↧
Labview crash related to Virtual Bench 8012
↧