I have downloaded the NI Bridge-Continuous Input Program and am trying to modify it slightly to allow for multiple Wheatstone bridges to be connected. Currently, it has the option to connect to a single channel but not to acquire information from multiple channels simultaneously. All of the information in terms of shunt calibration, bridge information, and waveform graph output will remain the same. Ideally, the program will show the largest value in the final waveform graph but it's fine if it shows separate graphs for each of the two inputs. I have been playing around with it without much luck although if I start from scratch and use the DAQ assistant I am able to get the information without trouble. Any help would be much appreciated.
↧