Hello NI guys!
I'm new here (and not that excellent at labview either) however my team is struggling and I thought I could see if anyone here knows how to solve our dilemma.
We are trying to hook Kistler foot force plates up to labview (as far as i know, Bioware and labview don't communicate well). Anyway, we came upon the problem of needing to use our DAQpad to generate a 5 volt digital signal to send to the force plates, as they require this to essentially turn them on, making data acquisition possible from then on.
We can't seem to figure out how to get labview to generate a signal like that.
The DAQpad we are using is NIUSB-6008 if that is necessary information.
Also our force foot plates are model 9286AA (doubt that that's necessary though).
Thanks if you guys can give any assistance!