Hey everyone, I am currently encountering an issue while attempting to read a voltage input signal through my cRIO 9048 system using LabVIEW version 2023 Q3. The voltage input is sourced from a Coriolis mass flow meter and is connected to an NI 9923 module in slot 2 of the cRIO.Upon attempting to implement the VI created for this purpose, I am encountering Error -209836. (Which is "The devices in your task cannot be synchronized. This may be because there are no available synchronization mechanisms between the devices.
Some synchronization paths are not available in interactive tools like the DAQ Assistant. To determine whether synchronization between these devices is possible, try deploying and executing your task in your application environment.)
Despite also trying to utilize an example VI provided in the LabVIEW documentation, I am still encountering the same error.
I have diligently followed the guidance provided in the NI documentation, ensuring that all drivers are installed correctly. However, the error persists.
One aspect worth noting is that the NI 9923 module in use is a Real-Time Resource module, rather than a Real-Time Scan module. Could this difference in module type potentially be contributing to the synchronization error?
Additionally, there is a known bug in LabVIEW 2023 Q3 that restricts the use of the DAQ Assistant through Express VI. Could this bug be related to the issue I am encountering with DAQmx, and if so, how?
I kindly request assistance in diagnosing and resolving this synchronization error. If further information about my system configuration is needed to facilitate troubleshooting, please do not hesitate to ask.