I am working on a project where i am using a 9054 as well as a 9147. Both have custom FPGA Code. I have set the FPGA LED to flash to know it is alive and working
I had everything working this week, but today it decided not to work.
Basically I woudl compile the 9147, reboot and off and running, then I would compile and boot the 9074, as soon as it powers back on the 9147 LED stops and is not functional. the 9054 boots fine everytime. I hasd this issue a coupe days ago, at that time I found there was a mismatch somewhere. I fixed and was up and running again. today I spent 3 hours trying to find the issue, conifrming everything was compiled correctly with no luck..
My next step is to format both systems and start over.. I will say due to some unplanned events with versions of LabVIEW, this is being done on 2024 Q1, 32bit
I am stumped and looking for ideas and suggestions on what to try next. I am working remote the next few days and have a duplicate set of chassis's here to work with..
Thanks