Keithley 2701 - Remote Triggering the Master Limit

Hi,

I am making a program that requires me to remotely flip the DMM 2701's master limit. I found the command needed to do this from the manual (CALCulate3:MLIMit:LATChed <b>) where <b> is ON or OFF. I have tried this command in the VISA test panel from within NI MAX as well as in the "EXECUTE REMOTE COMMANDS" section of the instruments website but even if I get a response from the instrument, the master limit latch does not switch.

Any advice on how to proceed with this issue would be greatly appreciated.

Thank you.