Need some help setting up the initial configuration, and understanding how to configure the Ramp, Temp, and Hold with the CN7500 from OMEGA.
Typical Ceramics kiln control I currently want to setup looks something like this below, and I use this with a Skutt Ceramic Kilm today.
Temp: temperature to obtain.
Rate: Degrees F per hour to increase. (9999 indicates unlimited time to drop to the desired temperature).
Hold: Time to hold when temperature achieved
Temp Rate Hold
950 300 00:20
2000 375 00:00
2250 300 00:00
2350 108 00:20
2000 9999 00:15
1950 9999 03:30
2000 300 01:00
2050 300 00:30
Thank You any help is appreciated.