hi everyone
i am sure you have heard of this a lot ..... but i am new (like 20 minutes old) to labview. i am quite fimiliar with matlab and other programming languages. i am doing a project based on software defined radio. for that i understood an example demo from matlab where a fully functional software transceiver has been built as an example.
now i myself have to do that in labview for the sake of comparison and better real time compatibility with USRPs. i am just getting started and was hopping if there is a similar example in labview or someone else's project. i have installed the modulation toolkit and have gone through its various blocks. i understand that i can build a tranmitter and receiver from scratch but that would take a lot of time and testing. so can anyone help me out in any way.....?
regards
khurram