Hi,
I am using Measurement & Automation Explorer version 5.1.0f0. I have previously configured my accelerometer using this module. Under setting, I have used g as my scaled unit. The sensitivity units is set at mVolts/g. This is just fine.
However when I tried to change the scaled units to m/s^2. I DID NOT get the option to set the sensitivity units into mVolts/m/s^2.
Is it OK to continue using mVolts/g for sensitivity units even when I had changed the scaled units to m/s^2. Since the two engineering units are different, will the accelerometer output correctly give out m/s^2 reading or I have to make some adjustment at the vi post acquisition like dividing with 9.8?
Thanks