Hi everyone,
I'm new to LabView and I am trying to modify a Futek example file (which processes the signal from our Futek device into firmness values) so that I can capture and record, in spreadsheet format, only the Maximum values each time we take a reading. I have been able to set it up so that the max value is found, and then reset once the device reads below 0.03 (the device rests at values above 0.02 when no force is being applied).
My modifications are in the while loop within the while loop on the right-hand side of the block diagram. As you can see, the values are in double precision format and and I am having trouble logging them into spreadsheet format.
Also, even if I were to log the values to a spreadsheet, I do not know how to retain only the max values each time the device is used and discard all other values.
Any thoughts?