Hello,
I am running a NI9239 Using 4 channels at 25k sample rate. I am taking the data in and triggering off events based on the voltage change.
The issue I am having is I have certain times that I want to ignore the results of the trigger. I have a 0-5v signal that I can trigger the ignore off from but don't have enough channels on the 9239 to add that sample data. What I do have is a ton of USB6008's left over from another project.
What I would like to do is trigger off my events with the 4 channels on the 9239 and ignore certain times using the 6008. When I try to take in the data with two DAQ assistance it will run for a short time 30 seconds to a few minutes then crash with a buffering error.
Thanks in Advance
-Joseph