Hi everyone,
I am confused by wait function in LabVIEW. I have a while loop and the calculation time duration for each iteration is about 0.1ms without using wait funtion inside of the loop. However when I tried to add wait function and set the wait time to be 1ms, the average iteration duration became 5ms. Does it mean the iteration took 5ms to run each time? If it is the case, how did I get 0.1ms before using wait function? I also tried to add the wait time from 1 to10 and before 5 it gave me similar answer 5ms after 5 it give me the number I specified to it, so I think it works fine. I also attached my VI to it, I am using cRIO to run this VI so it wont work on the computer but the idea should be clear.