My signals are all fine up until I get to the divide function. Then it goes to zero.
I inserted indicators at each wire until I found the spot my signal dropped to zero.
I have never seen an error passthrough like the one i get from this signal.
It is a 0-25 in wc dp gauge that reads just fine on my indicators for it.
It reads good after I convert to in Hg and after I add in the baro reading.
It zero's at the divide symbol. It is being divied by °R. I read in °R no problem.
It should read around .05. My other indicators have no problem showning a lower number.
I checked that my indicator wan't set to a lower resolution.
