Hello,
I am trying to create a labview application to act as a Modbus master and control multiple stepper motors. I have the DSC module in labview and am using a serial communication with an RS-485 converter. I have followed this guide: http://www.ni.com/white-paper/13911/en/ However, the driver I am using does not support coils, it only uses input and holding registers and I have not found a guide or tutorial that shows me how to create a labview application that can read and write to a specific address. For now all I want to do is turn the motor on and off using labview. I have used a modbus simulator to communicate with the driver and can do everything I want to do through the simulator. I can not get labview to do anything for me. I would be very happy if someone could direct me to a tutorial that can help me understand labview dsc module for reading and writing to addresses using modbus.
Meesh