Hi all,
Its been a while that I posted here on the forum. I was out of touch from labView but recently I started working again. Currently I am working with PCI 6514 Daq card. The card has port4~7 working as digital output ports. Now the problem I am facing with is that all the ports were working fine till suddenly complete port 4 stopper working, soo instead I started using port 5 and then after a while same happend to it. I have been trying to figure it out that what happend but till now it doesnt make any sense to me. My setup is simple, I connect SH100-100-F Cable from the PCI card to the SCB-100 connector block. No external power source or anything. but strangly the ports are not working. Is there anyway to reset the card. Or anyone had the same problem ?
Best Regards