Hey all-
I am completely new to LabView, and I've been struggling to teach myself though it to get the results I'm looking for recorded. I'm hoping someone could take a few minutes and lend me a helping hand.
I need (what I'm assuming is) a very simple VI that will read and record pressures from my two pressure transducers on screen and save out to an excel file so I can work with the data. I have two Omega pressure transducers, one is a P209X (reads 0-30PSI) and the other is a P309X (reads 0-3000 PSI). Both have a 0-5V output.
I've set up a crude VI that I can read the voltage outputs from my two transducers, but I'm not sure how to get it converted to PSI. I'd prefer a numeric LCD type number display rather than a line graph for both pressures so i can set my pressures, and then cycle the system and record the data.
I'm using LabView 2013 with a USB-6216, and have the P309x on A0 and the P209X on A1.
I'm basically recording input pressure and output pressure on either side of a regulator.
I certainly appreciate any help.
Thanks!
Carey