Dear Sir
I am using labview 2012 .I am totally new to cRIO based (9012) controller. first i set up network connection as a "Obtain IP address automatically" and
i connect crio 9012 controller to my Pc directly trough the RJ-45 connector.At that time Crio 9012 was detected in NI MAX (my remote system).
At that time Power LED was always on & States LED was once getting on after that getting off. but i checked ipconfig in command promt .
It showed some IP address.in Network Connection It showed "undefined Network connection" so i decide to configure the controller freshly.
i format the crio controller by using States Dip switch ON position and it showed formet completed sucessfully.
After that i changed States DIP switch and reset the controller . Right now i am facing proplem . i don't know how to configure the
crio controller. Now controller is not detecting in NI MAX (my remote system) . But It shows "undefined Network connection" in Network Connection.
Right now Power LED always in ON position & States LED also in ON position . Please help me to reconfigure the Crio controller as soon as possible.
Regards
Vinoth Edison
