Setting Up NI 9237 with Load Cells

All,

I am trying to set up a NI 9237 cDAQ module to read 4 signals from load cells, as follows;

Load Cell Capacity: 1000lb

Load Cell Sensitivity: 3mV/V

Excitation Voltage: 3.3V (Internal)

Bridge Configuration:  Full Bridge

I have AI+ connected to Pin 2, AI- to Pin 3, EX+ tp Pin 6, EX- to Pin 7, RS+ tied to EX+ (Jumper Pins 4 and 6), RS- tied to EX- (Jumper Pins 5 and 7), SC not connected

Questions:

1.  Have I wired this correctly?

2.  Can anyone post sample code which will display load values?

Thanks in advance.