NI-USRP RIO FPGA Rebuild needed without changes

Hello,

I'm trying to get into using our USRP RIOs NI-2943R with LabVIEW Comms 2.0.

I started with the Example USRP RIO 120-160 Mhz Multi Device Streaming that comes with the NI-USRP.

Opening the example and running it works perfectly fine.

Then after stopping it, no changes are made, just hitting the run button directly again LabVIEW tells me the FPGA Code is not up to date and has to be rebuild.

After rebuilding it, the VI runs ones and then same Message comes, still no changes made. Not even a Parameter adjusted.

Rebuilding takes roughly 1 hour so right now this kills any kind of workflow.

Is this working as intended ?

Setup is PXIe-8133 controller running Windows 7. All LabVIEW stuff up to date. NI-2943R connected over PXI Hub.