Folks, I need help to troubleshoot the excessive run delay with my application. Here is a description of what is going on.
1. I have an Analog Input voltage task consisting of 16 channels.
2. I have my Number of Samples per channel set at 128, and Sample Rate (samples per seconds) set at 1024. Am doing Continous mode of application, and am using USB 6218 as my DAQ device.
3. I have an Event structure in my application with Event Timeout as 10ms.
PROBLEM:
The problem am currently experincing is that whenever I open my application and click on RUN to tun the application, it takes at least 2 minutes before I start seeing plots on my waveform charts even while the continous RUN button is showing black indicating that the application is running. When the application starts plotting signals on my waveform charts, it begins as a very fast stream, and the slows down/settles on a steady average speed after some few seconds. I still can not figure out why it takes about two minutes to start plotting my signals even when the application is showing that it is running and when it finally starts plotting, it comes with a very fast speed.
I would appreciate any troubleshooting hint.
Regards