Hello, to give the short version of my question: is to possible for a project to run two different targets simultaneously? (Specifically a MyRio and the Computer itself) and share data between the two?
A little backstory: I am trying to make a thermal camera work with Labview, and it works fine when the VI is executed without a MyRio as the target. However, if I try to run it after I set MyRio as my target, this error occurs: "LabVIEW: Failed to load shared library Advapi32.dll:RegQueryValueExA:C . Ensure that the library is present on the RT target. Use either MAX to install NI software or FTP to transfer custom libraries to the RT target."
I researched this error, and it seems like it would be difficult to solve being that I am using a third party VI. So instead of going that route, I was wondering if there any way I could run a VI not on the MyRio, and one on the MyRio simultaneously and exchange data between the two. I tried using global variables but it didn't seem to work. Any sort of solution would be appreciated, thank you.