Hi all,
We have a home-built high voltage controller ( -5 kV ~ +5 kV). On the box, there are only two dials which adjust positive voltage and negative voltages individually. We use NI USB-6008 DAQ and Labview 8.6 version. The question is how to program the sequence as follow.
When the high voltage is turned on. Positive voltages go first from 0 to +5 kV, then negative follows from 0 to -5 kV.
When the high voltage is turned off. Negative goes first from -5 to 0 kV, then positive voltages change from +5 to 0 kV.
All the adjustment is kept at a rate of 1 kV/min.
Thanks.