Hey everyone
I've designed pressure system(dp cell) with a manifold of 8 ports at each of which solenoid valve. What I'm trying to do is to control the valve through labview so the open 1 at the time, stay open for 30 seconds then close and another one is opened and so on. I've attached the data sheet of the valves. I'm using Cdaq 9178 with NI:9203 and Ni :9472.
The valves are normally closed and the fluid passing through them is silicon oil.
I've been trying to look at different examples but I got confused.
I should be grateful for any advice or suggestion you give. (I started using labview only few weeks ago).
Best Regards
Rajab