Hi,
I am fairly new LabVIEW user and I am trying to send an analog output pulse through an NI 9269 to an NI 9219 on the same chassis NI cDAQ-9184. I am using the custom_pulse_generator.vi I found through the NI website. I was able to get the hardware to communicate on the AO and I am user jumper wire from a single the AO to a single AI, however, I cannot get the AI waveform graph to pull up the pulse data on the front panel. I have tried with/without while loops around the DAQmx read VI, to no success. The AI is simply to verify what AO pulse signal is actually being sent out.
This is the only hardware I have available. I have attached the VI for reference.
Any help is appreciated.
GF