Hi Guys,
I run to a problem after reinstall labview 2014. When I open the existing project. It started to looking for the control file. File name is UART.lvlib: Visa Configuration.ctl
Then I click cancle and the errors show up on the front panel and the run arrow was broken.
After I click on the show errors, it send me to the SMC Visa Configuation location
Then I double click on the SMC file it show up the block diagram for the smc file and the visa was disable in the picture below
Please help me figure out the problem.
I dont know which add on or drivers should I install. I install the NI Visa driver and the control and simulation driver already but it didnt fix the problem.
Hope you can help us identify the problem.
Thanks in advance!
Long Tao