Hi All
I have been tasked with writing a LabView application to test the functionality of all the input and outputs of a PXI 6713 module. All was going well until I tried to get an output from the 'FREQ OUT' and 'EXT STROBE' pins. User manual briefly mentions these pins as outputs but when I try to configure in DAQmx they are not selectable as physical channels. Can someone please tell me how to configure them to give an output that I can measure.
I'm using LabView 2011, MAX 5 .0 and DAQmx 9.3.5
Thanks in advance
I have been tasked with writing a LabView application to test the functionality of all the input and outputs of a PXI 6713 module. All was going well until I tried to get an output from the 'FREQ OUT' and 'EXT STROBE' pins. User manual briefly mentions these pins as outputs but when I try to configure in DAQmx they are not selectable as physical channels. Can someone please tell me how to configure them to give an output that I can measure.
I'm using LabView 2011, MAX 5 .0 and DAQmx 9.3.5
Thanks in advance